Analysis of the Effect of Magnetic Thickness and Rotating Speed on PMSG 24 Slot 16 Pole Characteristics

Achiruddin Lubis, Zulfatri Aini

Abstract


Wind energy is one of the alternative energies that can overcome global warming caused by fossil energy. Permanent Magnet Synchronous Generator (PMSG) has a higher efficiency compared to other types of generators. The previous permanent magnet synchronous generator model was only able to produce efficiency at a rotational speed of 500 rpm of 67.30% and at a rotational speed of 1500 rpm of 80.9%, so further research is needed to get a higher efficiency value. This study aims to analyze the effect of magnetic thickness and rotational speed on PMSG characteristics and obtain a higher efficiency value. Using variations in magnetic thickness of 7.5mm, 9 mm, and 10 mm and variations in rotational speed of 500 rpm, 1000 rpm,  and 1500 rpm using software based on Finite Element Methode, this study obtained the results of the largest current, voltage, input power, and output power at a magnetic thickness of 10mm with a rotational speed of 1500 rpm of 20.40 A, 204.06 V, 4979.60 W, and 4266.21 W, with the greatest efficiency being in the magnetic thickness of 9mm and 10 rpm of 89.20%

Keywords


Magnetic thickness; rotating speed; efficiency; PMSG

Full Text:

PDF

References


I. Bagus, F. Citarsa, I. Ayu, dan S. Adnyani, “Pengaruh Ketebalan Magnet Rotor terhadap Back EMF dan Efisiensi Permanent Magnet Synchronous Generator 12S8P,” vol. 9, no. 1, hal. 11–17, 2022, [Daring]. Tersedia pada: https://dielektrika.unram.ac.id

V. R. D. Rohmad, Bayu Aji Saputro, “G-Tech : Jurnal Teknologi Terapan,” G-Tech J. Teknol. Terap., vol. 6, no. 2, hal. 100–109, 2022.

Y. Mastanamma dan D. Subbarayudu, “Permanent magnet synchronous generator for wind energy conversion systems (WECS): A review,” Int. J. Recent Technol. Eng., vol. 7, no. ICETESM18, hal. 217–221, 2019.

C. Y. Hsiao, S. N. Yeh, dan J. C. Hwang, “Design of high performance permanent-magnet synchronous wind generators,” Energies, vol. 7, no. 11, hal. 7105–7124, 2014, doi: 10.3390/en7117105.

M. N. Fikri, U. C. Buana, dan D. B. Santoso, “Desain Permanent Magnet Synchronous Generator Untuk Pembangkit Listrik Tenaga Bayu Daya 500 Watt Dengan Kecepatan Angin Rendah,” JTEV (Jurnal Tek. Elektro dan Vokasional), vol. 8, no. 2, hal. 200, 2022, doi: 10.24036/jtev.v8i2.116750.

W. A. Oktaviani, T. Barlian, dan Y. Apriani, “Studi Awal Karakteristik Tegangan Ouput Generator Magnet Permanen dan Generator DC pada Turbin Kubah Masjid Putar,” Electrician, vol. 14, no. 2, hal. 56–63, 2020, doi: 10.23960/elc.v14n2.2149.

U. M. Area, “Analisa modifikasi motor induksi menjadi Permanent Magnet Synchronous Generator tiga fasa dengan Menggunakan Finite Element Method ( FEM ) SKRIPSI Oleh : Deni Arianto Barus FAKULTAS TEKNIK Analisa modifikasi motor induksi menjadi Permanent Magnet Synchron,” 2022.

Y. Jiang, Z. Zhang, W. Jiang, W. Geng, dan J. Huang, “Three-phase current injection method for mitigating turn-to-turn short-circuit fault in concentrated-winding permanent magnet aircraft starter generator,” IET Electr. Power Appl., vol. 12, no. 4, hal. 566–574, 2018, doi: 10.1049/iet-epa.2017.0754.

S. Arthur, E. Sumawang, dan S. Pramono, “Analisis Perubahan Jumlah Slot pada Permanent Magnet Synchronous Generator ( PMSG ) untuk Mencapai Nilai Optimal Back EMF dan KE berbasis Finite Element Method ( FEM ),” vol. 43, no. 2, hal. 140–146, 2022, doi: 10.14710/teknik.v43i2.44519.

R. Saputra dan Z. Aini, “Analisis Pengaruh Ketebalan dan Jenis Inti Besi Rotor Stator terhadap Karakteristik Generator Sinkron Magnet Permanen 18S16P Fluks Radial,” J. Sains, Teknol. dan Ind., vol. 18, no. 2, hal. 220–227, 2021.

M. I. Umami, I. M. A. Nrartha, dan T. Zubaidah, “Desain Generator Sinkron Magnet Permanen Jenis Neodymium Iron Boron Untuk PLTB Daya 500 Watt Menggunakan Perangkat Lunak MagNet Infolytica,” Dr. Diss. Univ. Mataram, hal. 1–7, 2018.

F. N. Rangkuti, M. Rokhmat, dan I. N. Zahra, “Perancangan Bilah Taper Pada Turbin Angin Sumbu Horizontal Design of Taper in Horizontal Axis Wind Turbin,” Univ. Telkom, vol. 8, no. 2355–9365, hal. 5834, 2021, [Daring]. Tersedia pada: Fadilah Novyanti Rangkuti; Mamat Rokhmat; Inayah N Zahra

Liliana, Z. Aini, A. Wenda, dan T. D. Putri, “Effect of Thickness and Type of Magnet against EMF Back PMSG 12S8P with FEM,” IOP Conf. Ser. Mater. Sci. Eng., vol. 990, no. 1, 2020, doi: 10.1088/1757-899X/990/1/012006.

Y. Liklikwatil, “Analisa pengaruh pergerakan fluks magnet eksitasi di dalam generator listrik terhadap tegangan keluaran,” Isu Teknol., vol. 15, no. 2, hal. 51–55, 2020.

T. P. Zaputra dan N. Gusnita, “Analisis Pengaruh Jumlah Lilitan dan Kecepatan Putar Terhadap Efisiensi Pada Permanent Magnet Synchronus Generator 18 Slot 16 Pole,” JTEV (Jurnal Tek. Elektro dan Vokasional), vol. 8, no. 2, hal. 411, 2022, doi: 10.24036/jtev.v8i2.117875.

T. D. Putri, “3279-10571-1-Pb,” vol. 11, no. 1, hal. 45–50, 2022.

M. I. Yasyak, P. Studi, T. Elektro, F. Teknik, dan U. M. Surakarta, “Naspub FIX_Muhamad Ibnu Yasyak_D400170137 (1),” 2021.




DOI: https://doi.org/10.33387/protk.v10i3.6059

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.



Editorial Office :
Protek : Jurnal Ilmiah Teknik Elektro
Department of Electrical Engineering. Faculty of Engineering. Universitas Khairun.
Address: Jusuf Abdulrahman 53 Gambesi, Ternate City, Indonesia.
Email: protek@unkhair.ac.id, WhatsApp: +6282292852552
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

View Stat Protek