Analysis of the Effect of Magnetic Thickness and Rotating Speed on PMSG 24 Slot 16 Pole Characteristics
DOI:
https://doi.org/10.33387/protk.v10i3.6059Keywords:
Magnetic thickness, rotating speed, efficiency, PMSGAbstract
Wind energy is one of the alternative energies that can overcome global warming caused by fossil energy. Permanent Magnet Synchronous Generator (PMSG) has a higher efficiency compared to other types of generators. The previous permanent magnet synchronous generator model was only able to produce efficiency at a rotational speed of 500 rpm of 67.30% and at a rotational speed of 1500 rpm of 80.9%, so further research is needed to get a higher efficiency value. This study aims to analyze the effect of magnetic thickness and rotational speed on PMSG characteristics and obtain a higher efficiency value. Using variations in magnetic thickness of 7.5mm, 9 mm, and 10 mm and variations in rotational speed of 500 rpm, 1000 rpm, and 1500 rpm using software based on Finite Element Methode, this study obtained the results of the largest current, voltage, input power, and output power at a magnetic thickness of 10mm with a rotational speed of 1500 rpm of 20.40 A, 204.06 V, 4979.60 W, and 4266.21 W, with the greatest efficiency being in the magnetic thickness of 9mm and 10 rpm of 89.20%Downloads
References
I. Bagus, F. Citarsa, I. Ayu, dan S. Adnyani, “Pengaruh Ketebalan Magnet Rotor terhadap Back EMF dan Efisiensi Permanent Magnet Synchronous Generator 12S8P,†vol. 9, no. 1, hal. 11–17, 2022, [Daring]. Tersedia pada: https://dielektrika.unram.ac.id
V. R. D. Rohmad, Bayu Aji Saputro, “G-Tech : Jurnal Teknologi Terapan,†G-Tech J. Teknol. Terap., vol. 6, no. 2, hal. 100–109, 2022.
Y. Mastanamma dan D. Subbarayudu, “Permanent magnet synchronous generator for wind energy conversion systems (WECS): A review,†Int. J. Recent Technol. Eng., vol. 7, no. ICETESM18, hal. 217–221, 2019.
C. Y. Hsiao, S. N. Yeh, dan J. C. Hwang, “Design of high performance permanent-magnet synchronous wind generators,†Energies, vol. 7, no. 11, hal. 7105–7124, 2014, doi: 10.3390/en7117105.
M. N. Fikri, U. C. Buana, dan D. B. Santoso, “Desain Permanent Magnet Synchronous Generator Untuk Pembangkit Listrik Tenaga Bayu Daya 500 Watt Dengan Kecepatan Angin Rendah,†JTEV (Jurnal Tek. Elektro dan Vokasional), vol. 8, no. 2, hal. 200, 2022, doi: 10.24036/jtev.v8i2.116750.
W. A. Oktaviani, T. Barlian, dan Y. Apriani, “Studi Awal Karakteristik Tegangan Ouput Generator Magnet Permanen dan Generator DC pada Turbin Kubah Masjid Putar,†Electrician, vol. 14, no. 2, hal. 56–63, 2020, doi: 10.23960/elc.v14n2.2149.
U. M. Area, “Analisa modifikasi motor induksi menjadi Permanent Magnet Synchronous Generator tiga fasa dengan Menggunakan Finite Element Method ( FEM ) SKRIPSI Oleh : Deni Arianto Barus FAKULTAS TEKNIK Analisa modifikasi motor induksi menjadi Permanent Magnet Synchron,†2022.
Y. Jiang, Z. Zhang, W. Jiang, W. Geng, dan J. Huang, “Three-phase current injection method for mitigating turn-to-turn short-circuit fault in concentrated-winding permanent magnet aircraft starter generator,†IET Electr. Power Appl., vol. 12, no. 4, hal. 566–574, 2018, doi: 10.1049/iet-epa.2017.0754.
S. Arthur, E. Sumawang, dan S. Pramono, “Analisis Perubahan Jumlah Slot pada Permanent Magnet Synchronous Generator ( PMSG ) untuk Mencapai Nilai Optimal Back EMF dan KE berbasis Finite Element Method ( FEM ),†vol. 43, no. 2, hal. 140–146, 2022, doi: 10.14710/teknik.v43i2.44519.
R. Saputra dan Z. Aini, “Analisis Pengaruh Ketebalan dan Jenis Inti Besi Rotor Stator terhadap Karakteristik Generator Sinkron Magnet Permanen 18S16P Fluks Radial,†J. Sains, Teknol. dan Ind., vol. 18, no. 2, hal. 220–227, 2021.
M. I. Umami, I. M. A. Nrartha, dan T. Zubaidah, “Desain Generator Sinkron Magnet Permanen Jenis Neodymium Iron Boron Untuk PLTB Daya 500 Watt Menggunakan Perangkat Lunak MagNet Infolytica,†Dr. Diss. Univ. Mataram, hal. 1–7, 2018.
F. N. Rangkuti, M. Rokhmat, dan I. N. Zahra, “Perancangan Bilah Taper Pada Turbin Angin Sumbu Horizontal Design of Taper in Horizontal Axis Wind Turbin,†Univ. Telkom, vol. 8, no. 2355–9365, hal. 5834, 2021, [Daring]. Tersedia pada: Fadilah Novyanti Rangkuti; Mamat Rokhmat; Inayah N Zahra
Liliana, Z. Aini, A. Wenda, dan T. D. Putri, “Effect of Thickness and Type of Magnet against EMF Back PMSG 12S8P with FEM,†IOP Conf. Ser. Mater. Sci. Eng., vol. 990, no. 1, 2020, doi: 10.1088/1757-899X/990/1/012006.
Y. Liklikwatil, “Analisa pengaruh pergerakan fluks magnet eksitasi di dalam generator listrik terhadap tegangan keluaran,†Isu Teknol., vol. 15, no. 2, hal. 51–55, 2020.
T. P. Zaputra dan N. Gusnita, “Analisis Pengaruh Jumlah Lilitan dan Kecepatan Putar Terhadap Efisiensi Pada Permanent Magnet Synchronus Generator 18 Slot 16 Pole,†JTEV (Jurnal Tek. Elektro dan Vokasional), vol. 8, no. 2, hal. 411, 2022, doi: 10.24036/jtev.v8i2.117875.
T. D. Putri, “3279-10571-1-Pb,†vol. 11, no. 1, hal. 45–50, 2022.
M. I. Yasyak, P. Studi, T. Elektro, F. Teknik, dan U. M. Surakarta, “Naspub FIX_Muhamad Ibnu Yasyak_D400170137 (1),†2021.
Downloads
Additional Files
Published
How to Cite
Issue
Section
License
Copyright & License
Copyright, licensing, and reuse terms for articles published in Protek: Jurnal Ilmiah Teknik Elektro
1. Copyright
Authors who publish in Protek: Jurnal Ilmiah Teknik Elektro retain the copyright of their work. Copyright of each article is vested exclusively in its authors.
2. License
Articles in Protek are published under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0). Anyone may share and adapt the work under the following terms:
3. Author's Warranties
By submitting a manuscript, the author warrants that the article:
- is original and has not been published before;
- contains no unlawful statements;
- does not infringe the rights of others;
- is subject to copyright vested exclusively in the author(s); and
- includes any necessary permissions to quote material from other sources.
4. User Rights
Under CC BY-NC-SA 4.0, users may copy, distribute, display, and perform the work for non-commercial purposes only. When distributing the work, users must give proper credit to the authors and to Protek as the original place of publication.
7. Royalties
The parties agree that no royalties or other fees are paid to the authors for publication. To the extent legally permissible, authors waive any claim to royalties for the publication of their article.
8. Miscellaneous
- Protek publishes the article in electronic form and makes it freely available to the public, without charge to readers.
- The editors may modify the article to conform to the journal's style, including punctuation, spelling, capitalization, referencing, and usage.
Questions about copyright or licensing can be sent to protek@unkhair.ac.id. See also the Open Access Policy and Publication Ethics.

