Analysis of the Effect of Sea Salt, Volcanic Ash and Black Carbon Contamination on the Insulation Resistance of Porcelain Insulators
DOI:
https://doi.org/10.33387/protk.v13i2.10733Keywords:
Porcelain Insulator, Insulation Resistance, Pollutant DepositionAbstract
The reliability of porcelain insulators in power systems is strongly influenced by surface conditions, particularly contamination from environmental pollutants. Such contamination can significantly reduce insulation resistance, thereby increasing the risk of leakage currents and flashover. This study aims to analyze the effects of major pollutants—namely sea salt, volcanic ash, and black carbon—on the insulation resistance of porcelain insulators. An experimental approach was employed by testing insulators under clean conditions and comparing the results after artificial contamination with each pollutant under controlled temperature and humidity conditions. Insulation resistance was measured using a megohmmeter, and the data were processed using the arithmetic mean of ten repeated measurements and analyzed descriptively. The results show that the clean condition yielded the highest average insulation resistance of 518 MΩ. Sea salt contamination caused the most significant reduction (210 MΩ), followed by volcanic ash (240 MΩ) and black carbon (280 MΩ). The greater impact of sea salt is attributed to its hygroscopic nature, which forms a conductive electrolyte layer, while volcanic ash contributes through its mineral composition and moisture retention, and black carbon through conductive particle networks. It can be concluded that sea salt has the greatest impact on insulation resistance degradation, followed by volcanic ash and black carbon. Although the measured values remain within acceptable limits for medium-voltage systems, continuous contamination may increase the risk of insulation degradation. Therefore, appropriate maintenance and pollution control strategies are necessary to ensure long-term reliability.
Downloads
References
Purwanto, A., & Prabowo, T. (2021). Sistem Kelistrikan dan Peranannya dalam Pembangunan Infrastruktur Nasional. Jurnal Teknologi dan Rekayasa Energi, 10(2), 45–52.
Ologunwa, T. P., & Ayibuofu, E. E. (2024). Significant Difference in the Properties of Porcelain Insulator Produced through Slip and Press Cast Forming Techniques. International Journal of Engineering and Manufacturing, 14(1), 38 52
Mohammadnabi, S., & Rahmani, K. (2021). Influence of humidity and contamination on the leakage current of 230 kV composite insulator. Electric Power Systems Research, 194, 107083.
Himpunan Buku Petunjuk Operasi dan Pemeliharaan Peralatan Penyaluran Tenaga Listrik, PT.PLN (Persero) SE No. 032/PST/1984
Pusat Vulkanologi dan Mitigasi Bencana Geologi (PVMBG). (2023, 3 Desember). Press release erupsi Gunung Marapi, Sumatera Barat – kolom abu hingga 3000 m [Press release]. Geologi ESDM.
Wilson, T. M., Stewart, P., Sword Daniels, S., & Leonard, G. (2012). Insulator flashover and the resistivity of volcanic ash. Dalam Review of impacts of volcanic ash on electricity distribution systems (hlm. 40–47).
Naisbitt, Kevin Rolando (2018);“Analisis perbandingan tahanan isolasi dan arus bocor pada isolator berbahan silicon rubber dan keramik akibat pengaruh kontaminan abu vulkanik dan belerang”
Tobing, Obet Powell L. 2015. Pengaruh Kelembaban terhadap Arus Bocor Isolator Piring Jenis Porselen Terpolusi Abu Vulkanik. Universitas Sumatera Utara.
Wilson, J. B., Wardman, J. B., Bodger, P. S., Cole, J. W., & Johnston, D. M. (2012). Investigating the electrical conductivity of volcanic ash and its effect on HV power systems. Physics and Chemistry of the Earth, 45, 128–140.
Abdullah, F. S., Piah, M. A. M., Othman, N. A., & Din, A. (2022). Prediction of surface leakage current of overhead insulators under environmental and electrical stresses. Bulletin of Electrical Engineering and Informatics, 9(5), 2182-2190
Ngayakamo, B. (2019). Evaluation of dielectric and mechanical strength of high voltage porcelain insulators made from Tanzania ceramic materials [Tesis Magister]. Nelson Mandela African Institution of Science and Technology.
Kadam, J. D., & Gonnade, R. K. (2022). Failure Trends of High Voltage Porcelain Insulators Depending on the Constituents of the Porcelain. Applied Sciences, 10(2), 694.
MDPI (2023). Structural performance of porcelain insulators in overhead railway power systems: Experimental evaluations and findings. Buildings, 9(8), 138.
[16] A. A. Salem, K. Y. Lau, M. T. Ishak, Z. Abdul-Malek, and S. A. Al-Gailani, “Monitoring porcelain insulator condition based on leakage current characteristics,” Materials, vol. 15, no. 18, p. 6370, 2022.
Y. Zhang et al., “Research on the prediction method of porcelain insulator pollution degree based on electric field monitoring,” Electric Power Systems Research, vol. 233, 2024.
B. Goswami, “Innovative porcelain insulators: Prolonged durability and anti-contamination efficiency via nano-TiO2 photocatalyst integration,” International Journal of Crystalline Materials, vol. 1, no. 2, pp. 18–23, 2024.
A. Khan et al., “Analysis of electric field and leakage current of porcelain insulators under clean and polluted conditions,” Electric Power Systems Research, vol. 239, 2025.
J. D. Kadam and R. K. Gonnade, “Failure trends of high voltage porcelain insulators depending on the constituents of the porcelain,” Applied Sciences, vol. 10, no. 2, p. 694, 2022.
Downloads
Published
How to Cite
Issue
Section
License
Copyright & License
Copyright, licensing, and reuse terms for articles published in Protek: Jurnal Ilmiah Teknik Elektro
1. Copyright
Authors who publish in Protek: Jurnal Ilmiah Teknik Elektro retain the copyright of their work. Copyright of each article is vested exclusively in its authors.
2. License
Articles in Protek are published under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0). Anyone may share and adapt the work under the following terms:
3. Author's Warranties
By submitting a manuscript, the author warrants that the article:
- is original and has not been published before;
- contains no unlawful statements;
- does not infringe the rights of others;
- is subject to copyright vested exclusively in the author(s); and
- includes any necessary permissions to quote material from other sources.
4. User Rights
Under CC BY-NC-SA 4.0, users may copy, distribute, display, and perform the work for non-commercial purposes only. When distributing the work, users must give proper credit to the authors and to Protek as the original place of publication.
7. Royalties
The parties agree that no royalties or other fees are paid to the authors for publication. To the extent legally permissible, authors waive any claim to royalties for the publication of their article.
8. Miscellaneous
- Protek publishes the article in electronic form and makes it freely available to the public, without charge to readers.
- The editors may modify the article to conform to the journal's style, including punctuation, spelling, capitalization, referencing, and usage.
Questions about copyright or licensing can be sent to protek@unkhair.ac.id. See also the Open Access Policy and Publication Ethics.

