Impact of Reactive Power Fluctuation on the Performance and Insulation Loss-of-Life Rate of Industrial Power Transformers: A Case Study of the PT Semen Tonasa Electrical System
DOI:
https://doi.org/10.33387/protk.v13i2.12746Keywords:
ETAP, insulation ageing rate power factor, power transformerAbstract
Power transformer performance is strongly influenced by reactive power (VAR), yet the quantitative link between VAR fluctuation and insulation loss-of-life in heavy industrial systems remains under-documented. This study analyzes that link for six 70 kV power transformers (three at the Tonasa IV and three at the Tonasa V substations, 31.5–40 MVA) in the electrical system of PT Semen Tonasa, combining SCADA operational data, an ETAP load-flow simulation, and an analytical ageing-rate calculation based on IEC 60076-7. Varying reactive power from 1 to 10 MVAR at a fixed active power of 10 MW increased the loading level from 31.41% to 44.19% of the 80% operating limit, consistent with S = √(P²+Q²). SCADA records showed current rising and primary-side voltage falling as VAR increased, with all voltages (66.68–68.95 kV) remaining within ±10% of nominal. For the three Tonasa V units, hotspot temperatures of 65.42–75.23°C and loss-of-life rates of 0.022–0.069 pu/day were obtained, well below the 98°C/V = 1 design reference; Transformer #1 aged roughly 3.1 times faster than Transformer #2, reflecting its higher average loading (63.4% vs. 36.5% of the operating limit). The extrapolated remaining-life figures (79.7–250 years) are indicative rather than literal, given the short (3–5-day) SCADA window; the loss-of-life rate is therefore treated as the primary, more defensible indicator. Reactive-power compensation via capacitor banks or static var compensators is recommended to limit current, hotspot temperature, and insulation ageing.
Downloads
References
[1] J. Wang, X. Zhang, F. Zhang, J. Wan, L. Kou, and W. Ke, “Review on Evolution of Intelligent Algorithms for Transformer Condition Assessment,” Frontiers in Energy Research, vol. 10, p. 904109, 2022, doi: 10.3389/fenrg.2022.904109.
[2] H. Dirik, C. Gezegin, and H. S. Dirik, “Reactive Power Compensation with Hybrid Compensator Combining a Synchronous Motor and Switched Capacitors,” Electric Power Systems Research, vol. 216, p. 109010, 2023, doi: 10.1016/j.epsr.2022.109010.
[3] T.-D. Nguyen, A.-T. Bui, N.-K. Nguyen, T.-D. Bui, N.-Q. Dinh, and T.-D. Pham, “A Novel Hybrid DC–CC-Based Reactive Power Compensation Scheme to Improve Power Quality of an Electric Grid Considering the Efficiency of Asynchronous Induction Motors,” SSRG International Journal of Electrical and Electronics Engineering, vol. 10, no. 8, pp. 156–169, 2023, doi: 10.14445/23488379/IJEEE-V10I8P115.
[4] M. Ayaz, S. M. H. Rizvi, and M. Akbar, “Dynamic Power Factor Correction in Industrial Systems: An Automated Capacitor Bank Control Approach,” in 2023 2nd International Conference on Emerging Trends in Electrical, Control, and Telecommunication Engineering (ETECTE), 2023, pp. 1–6, doi: 10.1109/ETECTE59617.2023.10396685.
[5] S. Bilyaz, A. Bhati, M. Hamalian, K. Maynor, T. Soori, A. Gattozzi, C. Penney, D. Weeks, Y. Xu, L. Hu, J. Y. Zhu, J. K. Nelson, R. Hebner, and V. Bahadur, “Modeling the Impact of High Thermal Conductivity Paper on the Performance and Life of Power Transformers,” Heliyon, vol. 10, no. 6, p. e27783, 2024, doi: 10.1016/j.heliyon.2024.e27783.
[6] G. Kosobudzki, D. Dusza, M. P. Ciurys, and A. Leicht, “Reactive Power Compensation for Single-Phase AC Motors Using Integral Power Theory,” Energies, vol. 18, no. 10, p. 2641, 2025, doi: 10.3390/en18102641.
[7] M. A. Fahmi, E. Radwitya, and Hasan, “Rancang Bangun Kapasitor Bank Otomatis Berbasis Internet of Things (IoT) pada Rumah Tinggal,” Electrical Network Systems and Sources, vol. 3, no. 2, pp. 6–13, 2024, doi: 10.58466/entries.v3i2.1608.
[8] B. Rezaeealam, “Real-Time Monitoring of Transformer Hot-Spot Temperature Based on Nameplate Data,” IET Generation, Transmission & Distribution, vol. 17, no. 12, pp. 2789–2801, 2023, doi: 10.1049/gtd2.12884.
[9] A. Anca, B. Bakhtiar, and R. L, “Study of the Effect of Peak Load on Transformer Loss of Life at PT PLN (Persero) Rayon Daya,” Jurnal Teknologi Elekterika, vol. 16, no. 2, pp. 80–87, 2019, doi: 10.31963/elekterika.v16i2.1550.
[10] International Electrotechnical Commission, IEC 60076-7:2018 Power Transformers – Part 7: Loading Guide for Mineral-Oil-Immersed Power Transformers, Geneva: IEC, 2018.
[11] IEEE Std C57.91-2011, IEEE Guide for Loading Mineral-Oil-Immersed Transformers and Step-Voltage Regulators, Piscataway, NJ: IEEE, 2012.
[12] K. Kumar, B. G. Kumbhar, and S. Satsangi, “Assessment of Effect of Load Models on Loss-of-Life Calculation of a Transformer Using a Point Estimation Method,” Electric Power Components and Systems, vol. 46, no. 16–17, pp. 1808–1819, 2018, doi: 10.1080/15325008.2018.1511874.
[13] J. Lu, B. Brown, Q. Hong, C. Booth, and B. Stephen, “Impact of Reactive Power Assumptions on Physics-Informed Assessment of Transformer Ageing in Distribution Networks,” PHM Society European Conference, vol. 9, no. 1, pp. 1–9, 2026, doi: 10.36001/phme.2026.v9i1.5031.
[14] S. A. Giha Yidi, V. Sousa Santos, K. Berdugo Sarmiento, J. E. Candelo-Becerra, and J. de la Cruz, “Comparison of Reactive Power Compensation Methods in an Industrial Electrical System with Power Quality Problems,” Electricity, vol. 5, no. 3, pp. 642–661, 2024, doi: 10.3390/electricity5030032.
[15] R. S. Juwita and Liliana, “Forecasting Analysis of Power Transformer Loss of Life Based on Loading Using the Linear Regression Method,” Briliant: Jurnal Riset dan Konseptual, vol. 8, no. 3, pp. 723–730, 2023, doi: 10.28926/briliant.v8i3.1286.
[16] A. Pavlićević and S. Mujović, “Impact of Reactive Power from Public Electric Vehicle Stations on Transformer Aging and Active Energy Losses,” Energies, vol. 15, no. 19, p. 7085, 2022, doi: 10.3390/en15197085.
[17] L. R. Chandran, G. S. Ajith Babu, M. G. Nair, and K. Ilango, “A Review on Status Monitoring Techniques of Transformer and a Case Study on Loss of Life Calculation of Distribution Transformers,” Materials Today: Proceedings, vol. 46, pp. 4659–4666, 2021.
[18] N. Rosyidi A. S., G. Andika, E. Supriyadi, and Ariman, “Analysis of the Life Reduction of a 1250 kVA Transformer Due to Loading at a Private Hospital Transformer,” Sainstech, vol. 34, no. 1, pp. 52–63, 2024, doi: 10.37277/stch.v34i1.1997.
[19] A. Maruf and Y. Primadiyono, “Analysis of the Effect of Loading and Temperature on the Loss of Life of 60 MVA Power Transformer Units 1 and 2 at the 150 kV Kalisari Substation,” Edu Elektrika Journal, vol. 10, no. 1, pp. 1–10, 2021.
[20] K. M. Berdugo Sarmiento, J. I. Silva-Ortega, V. Sousa Santos, J. E. Candelo-Becerra, and F. E. Hoyos, “Improving the Operation of Transmission Systems Based on Static Var Compensator,” Electricity, vol. 6, no. 3, p. 40, 2025, doi: 10.3390/electricity6030040.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 Muh. Imran Bachtiar, Aksan, Rahmat Budiansa

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Copyright & License
Copyright, licensing, and reuse terms for articles published in Protek: Jurnal Ilmiah Teknik Elektro
1. Copyright
Authors who publish in Protek: Jurnal Ilmiah Teknik Elektro retain the copyright of their work. Copyright of each article is vested exclusively in its authors.
2. License
Articles in Protek are published under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0). Anyone may share and adapt the work under the following terms:
3. Author's Warranties
By submitting a manuscript, the author warrants that the article:
- is original and has not been published before;
- contains no unlawful statements;
- does not infringe the rights of others;
- is subject to copyright vested exclusively in the author(s); and
- includes any necessary permissions to quote material from other sources.
4. User Rights
Under CC BY-NC-SA 4.0, users may copy, distribute, display, and perform the work for non-commercial purposes only. When distributing the work, users must give proper credit to the authors and to Protek as the original place of publication.
7. Royalties
The parties agree that no royalties or other fees are paid to the authors for publication. To the extent legally permissible, authors waive any claim to royalties for the publication of their article.
8. Miscellaneous
- Protek publishes the article in electronic form and makes it freely available to the public, without charge to readers.
- The editors may modify the article to conform to the journal's style, including punctuation, spelling, capitalization, referencing, and usage.
Questions about copyright or licensing can be sent to protek@unkhair.ac.id. See also the Open Access Policy and Publication Ethics.

