Performance Analysis of 100 KVA Generator Set as AC Backup Supply at Panakukang Electrical Substation

Authors

  • Muh. Imran Bachtiar Politeknik Negeri Ujung Pandang
  • Andi Wawan Indrawan Department of Electrical Engineering, Electrical Engineering Study Program, Politeknik Negeri Ujung Pandang
  • Muammar Abidin Department of Electrical Engineering, Ujung Pandang State Polytechnic
  • Syarifuddin Nojeng Department of Electrical Engineering, Muslim University of Indonesia
  • Mochammad Apriyadi Hadi Sirad Department of Electrical Engineering, Universitas Khairun

DOI:

https://doi.org/10.33387/ijeeic.v3i2.12162

Keywords:

Substation, Generator Set, AC Back-up Power Supply, Blackout, Variable Frequency Drive (VFD)

Abstract

Substation AC backup supply reliability is critical for sustaining auxiliary equipment operation during grid blackouts. Prior studies on genset sizing and motor starting have not specifically addressed substation AC backup systems integrating continuous loads, non-continuous motor loads, and comparative starting methods. This study evaluates the adequacy of the existing 100 kVA prime / 110 kVA standby genset at Panakkukang Substation using field data collection and ETAP 19.0.1 simulation. The total continuous load is 9.342 kW, requiring a minimum genset capacity of 11.675 kW after applying a 46.7% demand factor and 125% safety factor (per NFPA 110 and ISO 8528-1). The existing genset adequately covers continuous loads at only 10.62% of standby capacity. However, simultaneous starting of the hydrant and oil pump motors exceeds genset capability under all methods tested: Direct-On-Line (DOL) causes a 24.00% voltage dip requiring 463.74 kVA; Wye-Delta reduces voltage dip to 17.48% requiring 231.87 kVA; and VFD limits voltage dip to below 3% requiring only 159.17 kVA, compliant with IEEE Std 1159-2019. This study recommends upgrading genset capacity to at least 160 kVA and adopting VFD motor starting to ensure reliable substation AC backup supply.

Downloads

Download data is not yet available.

Author Biography

Muh. Imran Bachtiar, Politeknik Negeri Ujung Pandang

Muh. Imran Bachtiar is a lecturer in the Department of Electrical Engineering, Bachelor of Applied Science (D4) in Electrical Engineering Study Program at Politeknik Negeri Ujung Pandang, Indonesia. He currently holds the academic position of Asisten Ahli with the civil service rank of Penata Muda Tingkat I (Grade III/b).

References

[1] R. Zhang, N. Zhou, X. Meng, Y. Chi, Q. Wang, and M. Zhang, “A New Starting Capability Assessment Method for Induction Motors in an Industrial Islanded Microgrid with Diesel Generators and Energy Storage Systems,” Electric Power Systems Research, vol. 210, p. 108099, 2022.

[2] H. Sekhavatmanesh, J. Rodrigues, C. L. Moreira, J. A. P. Lopes, and R. Cherkaoui, “Optimal Load Restoration in Active Distribution Networks Complying with Starting Transients of Induction Motors,” IEEE Transactions on Smart Grid, vol. 11, no. 5, pp. 4217–4228, 2020.

[3] J. Rodrigues, H. Sekhavatmanesh, C. L. Moreira, J. A. P. Lopes, and R. Cherkaoui, “A Convex Model for Induction Motor Starting Transients Embedded in an OPF-Based Optimization Problem,” Electric Power Systems Research, vol. 202, 2022.

[4] M. A. Hossain, M. A. Mahmud, and H. R. Pota, “A Probabilistic Load Flow for Unbalanced Three-Phase Islanded Microgrids Using Unscented Transformation,” International Journal of Electrical Power & Energy Systems, vol. 155, 2024.

[5] M. A. Ramli, M. H. Hannan, P. J. Ker, and M. S. H. Lipu, “Optimization and Energy Management for Cluster of Interconnected Microgrids with Intermittent Non-Polluting and Diesel Generators in Off-Grid Communities,” Electric Power Systems Research, vol. 241, 2025.

[6] IEEE Std 446-1995, “IEEE Recommended Practice for Emergency and Standby Power Systems for Industrial and Commercial Applications (IEEE Orange Book),” Institute of Electrical and Electronics Engineers, New York, NY, USA, 1995. doi: 10.1109/IEEESTD.1996.81014.

[7] Q. Long, H. Yu, F. Xie, N. Lu, and D. Lubkeman, “Diesel Generator Model Parameterization for Microgrid Simulation Using Hybrid Box-Constrained Levenberg-Marquardt Algorithm,” IEEE Transactions on Smart Grid, vol. 12, no. 2, pp. 943–952, 2021, doi: 10.1109/TSG.2020.3026617.

[8] D. N. Asainov and M. Shekari, “Optimizing the Quantity of Diesel Generators Considering Induction Motor Start-Up and Short Circuit Occurrence,” in Proc. IEEE Russian Workshop on Power Engineering and Automation of Metallurgy Industry (REEPE), 2024.

[9] M. J. Hossain, H. R. Pota, M. A. Mahmud, and N. Mithulananthan, “Robust Control for Power Sharing in Microgrids with Diesel Generator and Renewable Energy Sources,” IEEE Transactions on Sustainable Energy, vol. 12, no. 2, 2021.

[10] A. A. Kamil, L. A. Abdul-Rahaim, and S. Alwash, “ETAP-Based Analysis of Hybrid Energy Systems in Smart Grids,” Journal Européen des Systèmes Automatisés, vol. 58, no. 3, pp. 643–652, 2025.

[11] A. Bernstein, C. Wang, E. Dall’Anese, J.-Y. Le Boudec, and C. Zhao, “Load-Flow in Multiphase Distribution Networks: Existence, Uniqueness, Non-Singularity and Linear Models,” IEEE Transactions on Power Systems, vol. 33, no. 6, pp. 5832–5843, Nov. 2018. doi: 10.1109/TPWRS.2018.2823277.

[12] A. M. El-Zonkoly, “Optimal Placement of Distributed Generation for Power Losses Reduction in Distribution Systems Using ETAP-Based Analysis,” International Journal of Electrical Power & Energy Systems, vol. 130, 2021.

[13] ISO 8528-1:2018, “Reciprocating Internal Combustion Engine Driven Alternating Current Generating Sets — Part 1: Application, Ratings and Performance,” International Organization for Standardization, Geneva, Switzerland, 2018.

[14] IEEE Std 1159-2019, “IEEE Recommended Practice for Monitoring Electric Power Quality,” Institute of Electrical and Electronics Engineers, New York, NY, USA, 2019. doi: 10.1109/IEEESTD.2019.8796486.

[15] S. S. Akhmad, M. D. Faraby, M. I. Bachtiar, et al., “Genetic Algorithm to Determine Location and Size of Distributed Generation and Capacitor Bank at ULP Sungguminasa,” International Review on Modelling and Simulations, vol. 18, no. 1, pp. 75–82, 2025.

[16] S. S. Akhmad, M. D. Faraby, M. I. Bachtiar, et al., “Placement and Sizing Distributed Generation Using K-Means Clustering in ULP Sungguminasa 165-Bus Radial Distribution System,” in AIP Conference Proceedings, vol. 3140, 2024.

[17] S. Nojeng, Syamsir, and R. Murniati, “Impact of Micro Hydro Power Plants on Transient Stability for the Micro Grid 20 kV System,” Indonesian Journal of Electrical Engineering and Computer Science, vol. 24, no. 3, pp. 1278–1287, 2021.

[18] M. B. Nappu, A. Arief, and M. I. Bachtiar, “Strategic Placement of Capacitor and DG for Voltage Improvement after Large Penetration of Renewable Energy Power Plant: An Indonesian Study,” in Proc. 7th International Conference on Renewable Energy Research and Applications (ICRERA), Paris, France, 2018, pp. 627–631.

Downloads

Published

2026-06-30

How to Cite

Bachtiar, M. I., Indrawan, A. W., Abidin, M., Nojeng, S., & Sirad, M. A. H. (2026). Performance Analysis of 100 KVA Generator Set as AC Backup Supply at Panakukang Electrical Substation. International Journal Of Electrical Engineering And Intelligent Computing, 3(2 June), 63–71. https://doi.org/10.33387/ijeeic.v3i2.12162

Issue

Section

International Journal Of Electrical Engineering And Intelligent Computing

Similar Articles

1 2 > >> 

You may also start an advanced similarity search for this article.